Factory Direct Hardware Hansgrohe 39400 Axor Citterio - Manual (Page 4)

4
Seal the wall around the offset adapters with water-
proof sealant.
Place the gasket over the adapters. Press the mixer
firmly over the adapters. Use the included 5 mm hex
wrench to tighten the screws.
Set the high temperature limit stop (optional).
User Instructions
Pull up on the handle to turn the water on. Pivot the handle to the right to obtain cooler water, to
the left to obtain hotter water.
When the water is turned on, it will come out through the spout. Pull out on the diverter to divert
the water to the handshower port.
When the water is turned off, the diverter will re-set to the spout position.
Adjust the High Temperature Limit Stop (optional)
Lift the handle (1). Push the screw cover through into
the handle with the 4 mm Allen wrench (). Use the 4
mm allen wrench to loosen the handle screw 4 com-
plete turns (3). Remove the handle (4).