Factory Direct Hardware Hansgrohe 39116 - Manual (Page 2)


Citterio Wall-Mount Lavatory Trim
39115XX1
��
���
��
���
��
Technical Data
Maximum incoming water pressure 145 psi
Recommended incoming pressure 14.5 - 7 psi
Recommended hot water temperature 10 o F - 140 o F*
Flow rate . gpm
The hot and cold supplies must be of equal pressure for proper operation of the faucet.
*Know and follow all applicable local codes when setting the temperature of the water heater.
Installation Considerations
· Rough-in 38111181 (purchased separately) must be installed and the finished wall
complete before installation of this trim kit.
· For best results, Hansgrohe recommends installation by a licensed, professional
plumber.
· No drain is included with this faucet. Contact the manufacturer of the sink for
recommendations regarding suitable drains.
· Turn the water off at the main before beginning installation.
Recommended tools (not included)
7 mm & 17 mm deep sockets
1 mm allen wrench
Teflon TM thread tape
cutting tools
waterproof bathroom sealant, compatible with the wall surface