Factory Direct Hardware Hansgrohe 10406001 Axor Starck X - Manual (Page 8)

8
• Remove the handle screw. Pull the green
high temperature limit stop straight off
the cartridge.
• Reinstall the high temperature limit
stop so that the positioning pin on the
cartridge is in the hole for the desired
high temperature. The temperatures
shown on the diagram assume an
incoming cold water temperature of 50 o F
and an incoming hot water temperature
of 140 o F.
• Test the unit. Reposition the high
temperature limit stop again if required.
• Reinstall the nut cover. Reinstall the
handle screw and tighten four complete
turns. Reinstall the handle and continue
tightening the screw. Reinstall the screw
cover.
Reset the High Temperature
Limit Stop (Optional)
• Use a 4 mm allen wrench to push the
gray rubber screw cover through the
hole in the handle. Loosen the handle
screw 4 complete turns. Pull the handle
off. Retrieve the screw cover.
• Remove the nut cover and the handle
screw.
• Center the cartridge stem.