Factory Direct Hardware Belle Foret N30002 - Manual (Page 2)

Preparation/Assembly
2
Remove rubber washer, metal washer, lock nut, spout connector and
nut from spout shank. Position the spout in the faucet hole of the
sink. Slide the rubber and metal washers up the shank and secure
spout with the lock nut. Reattach spout connector and secure with
nut.
1
Shut off water supply before installation.
3
Remove lock nut, rubber washer and metal washer from hot valve
body. Wrap male threaded end of flexible spout connector hose, and
install in bottom of valve body. Insert valve body through the correct
faucet hole, replace rubber and metal washers, and secure with lock
nut.
4 Repeat step 3 for cold valve body.
Steps 1-4
1
2-2
2-1
3
Spout
Spout
Metal washer
Lock nut
Rubber washer
Screw
Spout connector
Metal washer
Lock nut
Rubber washer
Metal washer
Lock nut
Rubber washer
Canopy
Hot valve body
Spout connector hose
Metal washer
Lock nut
Rubber washer
Spout connector
Nut
Nut