Factory Direct Hardware LCN 2035 - Manual

1.
2.
3.
4.
Hand of door and closer must be the same.
RH or LH will be stamped on mounting plate.
See proper template for your application.
Attach arm to closer, as shown above. The bend
in arm will always point towards door.
Install closer including arm in prepped frame with
mounting screws provided. Be sure mounting plate
is flush with soffit.
After closer is mounted in door jamb, attach applied
stop to head frame, as shown above. Stop section
must have access hole to allow for door closer
adjustment.
5.
6.
7. closing power
Track mortise in top of door must match proper template.
Place roller in track as shown. Mount track in door with holes
for hold open clip toward hinge edge. Fasten with screws
provided.
Open door to approximately 45°. Pull arm over top of door.
Align hole in end of arm with roller stud. Fit closer arm
completely onto roller stud and tighten arm set screw securely.
Adjust only if more power is needed. Closer
is shipped with minimum closing power pre-set. To increase
closing power turn spring adjusting screw clockwise. Maximum
adjustment 36 turns.
2030 SERIES
INSTALLATION INSTRUCTIONS
09/06 ©2006 SCHLAGE LOCK Company. All rights reserved. DP# 18758R6
BACKCHECK
MAIN SPEED
LATCH
SPEED
APPLIED
STOP BY
OTHERS
HOLD OPEN INFORMATION
To install and adjust hold open option, see Fig. 1 and
follow these directions: Tip hold open clip into track.
Locate at desired hold open position and fasten with
screw . Tip cam into track & locate as shown. fasten
with screw . Push door into hold open position and check
for proper operation. To
holding power, loosen
screw and slide cam toward latch edge of door. To
holding power, slide cam toward hinge edge. Re-tighten screw .
3
1
increase
1 decrease
1
MAXIMUM
OPENING TORQUE
=
15 ft-lbs
21 N-m
! - DO NOT USE ABRUPT BACKCHECK- NOR
EXPECT DOOR CLOSER TO ACT AS A DOOR STOP!
CLOSING SPEED:
BACKCHECK:
See Closer Control Diagram below.
Regulating screw locations are shown in illustration at left and
also on door closer label. To adjust Main Speed, turn
regulating screw clockwise to decrease or counter-clockwise
to increase. To adjust Latch Speed, turn regulating screw
clockwise to decrease or counter-clockwise to increase.
This control hydraulically dampens the opening
speed of doors. Use enough backcheck to sufficiently slow the
doors opening speed. To increase resistance, turn
regulating screw clockwise.
8. The 2030 series closer has been regulated prior to
shipment. If adjustments are necessary, carefully follow
instructions. DO NOT REMOVE COVER PLATE TO MAKE
ADJUSTMENTS.
1-800-526-2400
®
IMPROPER INSTALLATION OR
REGULATION MAY RESULT IN
PERSONAL INJURY OR
PROPERTY DAMAGE. FOLLOW ALL
INSTRUCTIONS CAREFULLY. FOR
QUESTIONS, CALL LCN AT
800 - 526 - 2400
CAUTION !