Aba & aby installation (continued), Check installation, Clean up – Factory Direct Hardware Toto ABA974RY User Manual
Page 4: Trial operation
ABA & ABY Installation (continued)
Check Installation
AirBaths: Make sure the blower has ample unobstructed space to draw air and that the space is clear of dust and debris.
All bathtubs: Make sure the bathtub is level and supported by the feet or wood base or mortar sub-floor and not the flange lip.
Clean Up
•
When cleaning after installation, do not use abrasive cleaners, as they may scratch and dull the surface. Use warm water and a
liquid non-abrasive detergent to clean the surface.
•
Stubborn stains, paint or tar can be removed with isopropyl (rubbing) alcohol. Rinse well and dry with a soft, clean cloth.
•
Do not use metal scrapers, wire brushes or other metal tools.
Trial Operation
•
Close the drain.
•
Fill the bathtub.
•
Check for leaks from the air jets (AirBath only).
•
Check for leaks from the drain.
•
Check plug voltage and verify the Control Panel activates then the “ON” button is
pressed. (AirBath only - see Owner manual)
•
Check operation. (AirBath only - see Owner manual)
•
After operation, drain the bathtub and run the Automatic Maintenance Cycle. (AirBath
only - see Owner manual)
Drain
Jet Fitting
8
9
10
To the installer
•
Be sure to provide the customer with the Installation manual.
•
Fill out the necessary warranty information on the back off the Owner manual (for AirBaths).