Factory Direct Hardware Pfister F-049-YW1K - Manual (Page 4)

ENGLISH
ENGLISH
11
13
14
15
DRAIN BODY INSTALLATION
FAUCET FUNCTIONS
MAINTENANCE & CARE
12
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price Pfister
Consumer Service.
3. Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth to clean and
shine. Use of polish, detergents, abrasive cleaners, organic solvents or acid
may cause damage. Use of other than a soft damp cloth will nullify our
warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are not acceptable
for public areas or Commercial use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call 1–800–PFAUCET
(1–800–732–8238) or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
11 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (11A) into Water Supply Lines (11B). Then, insert Inlet
Connectors (11A) into Valve Bodies (11C).
Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer’s instructions when installing supply lines. Next, insert Clips (11D) into
Valve Body Holes (11E), to secure unit.
WARNING: Do not twist Inlet Connectors (11A) once installed!
12 POP-UP INSTALLATION
Install and adjust Pop-Up (12A) using separate instructions supplied with the Pop-Up
assembly.
13 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
14 FAUCET FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise.
15 VALVE CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet
(see step 2). Remove Handles (see step 7), unscrew Retainer Nut (15A) by turning it
counter-clockwise and lift out Cartridge Assembly (15B) and inspect. Replace parts
as necessary.
4
HOT
HOT
OPEN OPEN
COLD
COLD
15A
15B
12A
11A
11D
11D
11E
11D
11A
11B
11B
11C
11C