QTECH SmartEdge 600 Configuration - Manual (Page 20)

Configuring Authentication, Authorization, and Accounting
Table 18 Context-Specific RADIUS and Router Authentication
Task Root Command Notes
Configure context-specific
RADIUS authentication,
followed by router configuration
authentication. aaa authentication subs
criber Enter this command in the context
configuration mode.
Use the radius keyword followed by
the local keyword with this command.
At least one RADIUS server IP address
or hostname must be configured in the
current context; for more information,
see Configuring RADIUS.
2.2.2.10 Configure a Last-Resort Authentication Context
To specify a context to attempt authentication of a subscriber when the domain
portion of the subscriber name cannot be matched, perform the task described
in Table 19.
Table 19 Last-Resort Authentication Context
Task
Root Comma
nd
Notes
Configure a last-resort
authentication context. aaa last-reso
rt Enter this command in the global
configuration mode.
2.2.3 Disabling Subscriber Authentication
To disable authentication of subscribers in the current context, perform the
task described in Table 20.
Table 20 Disabling Subscriber Authentication
Task Root Command Notes
Disable subscriber
authentication. aaa authentication subs
criber Enter this command in the context
configuration mode. Use the none keyword
with this command if subscriber authentication
is not required, such as when Dynamic Host
Configuration Protocol (DHCP) is used to
obtain IPv4 addresses for subscriber hosts.
16 61/1543-CRA 119 1170/1 Uen L | 2012-12-04