SENA HD132x Series User Manual
Page 23
HD132x Series User Manual
23
When [IP Find] button is pressed, the following window will appear. Enter the MAC address of the
HelloDevice and press [Find IP]. The IP address that is currently set will appear in [Found IP] box.
Figure 4.10 [IP Find] Window
If you press [more..], [System info] window will appear, and you can observe information of the current
communication status of the HelloDevice. Figure 4.11 shows [System Info] window, and a simple
summary of each item in this Figure is shown in Table 4.1.
Note:
1) You can use [Find IP] and other system functions after setting the password parameter. (Refer
to Section 4.4.1)
2) You can use [Find IP] only in LAN (Local Area Network) of the same network [Hop]. Collecting
information from the remote location over the Internet is impossible.