Xoro HSD 2220 - Manual (Page 78)

34
Engl
ish
SETUP
Video Setup Page
The Video Setup Page includes the settings
for „Component“, „Scan Mode“, „Sharpness“,
„Brightness“ and „Contrast“.
Component
The setting component specify the kind of
video output.
RGB
This setting is useful, when you connect the
DVD player with your TV set and the TV set
has a SCART connector which supports
RGB signals. With RGB signals on SCART
you can get a better picture quality compare
to FBAS signals (YUV setting).
YUV
This setting is useful, when you connect the DVD player with your TV set and the TV set has
a SCART connector which does supports RGB signals. Here you need the YUV setting for
getting FBAS signal by SCART.
If you connect the DVD player with a 3-wire component cable and connect them by YPbPr to
your TV set, than please use also the YUV setting.
S-Video
If you connect the DVD player by S-Video with a S-Video cable to your TV set, than please
the setting S-Video.
Scan-Mode
This option is only than active, when you choose the Component setting YUV by using an 3-
wire component cable. Here you can choose “Progressive” or “Interlaced”. If your TV set
supports progressive scan by YPbPr than you can use this setting for getting the best pic-
ture quality by YUV. The player transmit than a 576p signal to the TV set. If your TV set are
not able to work with progressive scan, please choose only the option “Interlaced”. The
player transmit an 576i signal to your TV set.
Note:
If use a YUV connection than you can change during playback the setting “interlaced” to
“progressive” and back by pressing the P-SCAN button.
Sharpness
The options are “High”, “Middle” and “Low”. By the setting “Low” the DVD player produces a
very soften picture. By the setting “High” the picture is very sharp.
Brightness and Contrast
The settings for brightness and contrast can be changes by using the scroll bar, which are
displayed, when you want to change to settings.