Xoro HRT 7000 - Manual (Page 27)

HRT 7000 27
Engl
ish
SETUP
Installation
Channel Scan
When entering to Channel scan menu, you will
see the different sub-options. The sub-options
are:
•
Scan Mode
• Scan Band
• Ch No
• Frequency
• Bandwidth
• Search
Scan Mode
There are two choices of Scan Mode. You can scan channel by channel or frequency. If you choose
by scan by channel, than the sub-options Scan Band and Channel number (CH No) are editable.
The sub-options Frequency and Bandwidth can not changed. The parameters for frequency and
bandwidth are given from the region or country selection.
Scan Band
Here you can choose between UHF and VHF band. The frequency range by VHF band is between
174 to 230 MHz and by the UHF band between 470 to 862 MHz.
In case of the setting Frequency by Scan mode the option Scan Band disappears and can not
changed.
Channel Number (CH No)
Here you can choose one of 56 channels. If you choose a channel number than automatically
based on the country selection the parameters for frequency and bandwidth are given.
In case of the setting Frequency by Scan mode the option CH NO disappears and can not changed.
Frequency
This option are only than available, when you chosen the option Frequency by the Scan mode.
If this option is available than you can enter directly the frequency. Please pay attention that on the
selected frequency you can receive any signal. Helpfully to control this point is, to observe the
parameters Signal Intensity and Signal Quality.
Bandwidth
Here are three different settings to choose. You can uses 6, 7 or 8 MHz for the bandwidth.
Note:
Please uses the two option Frequency and Bandwidth when you are a professional. Otherwise, the
device can not find any channel.