SCANTECH ID (Champtek company) IG300BT - Manual (Page 3)

3
6.1 Factory Default ............................... 17
6.2 Scanning Triggering ...................... 17
6.3 Trigger Time Out ............................ 19
6.4 Good Read Mode .......................... 20
6.5 Buzzer Beep Tone ......................... 20
6.5.1 Beep Tone Setup ........................ 20
6.5.2 Good Read Beeps ...................... 21
6.5.3 Beep Duration ............................. 21
6.5.4 Timing .......................................... 22
6.5.5 Good Read Duration .................. 22
6.5.6 Error Beep ................................... 22
6.5.7 Setup Beep ................................. 22
7. Imager Settings .................................. 23
7.1 Imager Mode .................................. 23
7.2 Sleep Mode .................................... 24
7.3 Batch Mode .................................... 25
7.4 Firmware Version ........................... 26
7.4.1 Engine Firmware Version ........... 26
7.4.2 Scanner Decoder Firmware Version
26
7.4.3 Cradle Decoder Firmware Version
26
7.4.4 Scanner Bluetooth MAC Address 26
7.4.5 Cradle Bluetooth MAC Address . 26
7.5 Set Cradle Interface Barcode ........ 27
7.6 Cradle RS232 Communication
Parameter
....................................... 27
7.6.1 Cradle Baud Rate ....................... 27
7.6.2 Cradle Data Bits .......................... 28
7.6.3 Cradle Stop bits .......................... 28
7.6.4 Cradle Parity ............................... 28
7.6.5 Cradle Hand Shaking ................. 29
7.6.6 Cradle Keyboard Wedge Mode
Parameters ..................................... 30
7.7 Decoding Selection ........................ 35
7.7.1 Symbologies Selection ............... 35
7.7.2 Disable All Symbologies. .......... 44
7.7.4 Activates user defined symbology
identifier (UDSI) transmission for all
symbologies.
................................... 46