GE Industrial Solutions Galaxy Pulsar Edge - Manual (Page 33)

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011
33
interface. If present, this operation can also be performed at the front panel at Main
►
Control/Operations.
The controller remembers certain previous system configurations and conditions. Non-
existent alarm conditions should clear. If the system LED is not green and the alarm
LED is illuminated, review the installation procedure and refer to the troubleshooting
section. The controller display should only have the system (SYS) LED illuminated
green to indicate “NO ALARMS”.
6 Verifying a simple alarm
With the system in a normal operation mode, remove a rectifier from its slot. The
controller should illuminate its amber severity LED indicating a missing rectifier.
Condition. Return the rectifier to its slot. The controller should update the rectifier
status. If the above conditions did not yield the proper results, refer to the
troubleshooting section.