Asus M2N-LR/SATA - Manual (Page 42)

ASUS M2N-LR Series 2-2
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
Drive jumper setting Mode of
device(s)
Cable connector
Single device Cable-Select or Master - Black
Two devices Cable-Select Master
Black
Slave Gray
Master Master Black or gray
Slave Slave
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5,
SATA6)
Supported by the NVIDIA
® nForce™ 570 SLI MCP (MCP55P) chipset, these
connectors are for the Serial ATA signal cables for Serial ATA hard disk drives
that allows up to 3Gb/s of data transfer rate.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
RAID 10, RAID 5, or JBOD configuration. Refer to Chapter 5 for details on
how to set up the RAID configurations.
These connectors are set to SATA by default. In SATA mode, you can connect
Serial ATA boot or data hard disk drives to these connectors. If you intent to
create a Serial ATA RAID set using these connectors, enable the RAID function
of each port from the nVIDIA RAID Setup sub-menu item in the BIOS. See
section “4.4.7 Onboard Device Configuration” for details.
M2N-LR/SATA
®
M2N-LR/SATA SATA Connectors
SATA1
G
N
D
R
SA
TA
_T
XP
1
R
SA
TA
_T
XN
1
G
N
D
R
SA
TA
_R
XP
1
R
SA
TA
_R
XN
1
G
N
D
SATA3
G
N
D
R
SA
TA
_T
XP
3
R
SA
TA
_T
XN
3
G
N
D
R
SA
TA
_R
XP
3
R
SA
TA
_R
XN
3
G
N
D
SATA5
G
N
D
R
SA
TA
_T
XP
5
R
SA
TA
_T
XN
5
G
N
D
R
SA
TA
_R
XP
5
R
SA
TA
_R
XN
5
G
N
D
SATA2
G
N
D
R
SA
TA
_T
XP
2
R
SA
TA
_T
XN
2
G
N
D
R
SA
TA
_R
XP
2
R
SA
TA
_R
XN
2
G
N
D
SATA4
G
N
D
R
SA
TA
_T
XP
4
R
SA
TA
_T
XN
4
G
N
D
R
SA
TA
_R
XP
4
R
SA
TA
_R
XN
4
G
N
D
SATA6
G
N
D
R
SA
TA
_T
XP
6
R
SA
TA
_T
XN
6
G
N
D
R
SA
TA
_R
XP
6
R
SA
TA
_R
XN
6
G
N
D