Asus P8Q77-M - Manual (Page 62)

2-18 ASUS P8Q77-M
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When
read/write of your hard disk errors occur, this feature allows the hard disk to report warning
messages during the POST. Configuration options: [Enabled] [Disabled]
Hot Plug [Disabled]
This item only appears when you set the SATA Mode Selection item to [AHCI] or [RAID]
and allows you to enable or disable the hot-plug support for each SATA port. Configuration
options: [Enabled] [Disabled]
2.5.5 System Agent Configuration
Memory Remap Feature [Enabled]
Enables or disables the memory remap feature. Configuration options: [Enabled] [Disabled]
Graphics Configuration
Primary Display [Auto]
Allows you to decide which graphics controller to use as the primary boot device. Configuration
options: [Auto] [iGFX] [PEG]
iGPU Memory [64M]
Allows you to set the iGPU memory size. Configuration options: [32M] [64M] [96M] [128M] ~ [448M]
[480M] [512M] [1024M]
Render Standby [Enabled]
Allows you to enable or disable Render Standby by internal graphics devices. Configuration
options: [Disabled] [Enabled]
NB PCIe Configuration
PEG0
PEG0 - Gen X [Auto]
Sets PEG0 B0:D1:F0 Gen1~Gen3. Configuration options: [Auto] [Gen1] [Gen2] [Gen3]
PEG0 ASPM [Disabled]
Sets the ASPM support for the PEG: Device 1 Function 0. This function does not take effect
if PEG is not the currently active device. Configuration options: [Disabled] [Auto] [ASPM L0s]
[ASPM L1] [ASPM L0sL1]
PEG2 - Gen X [Auto]
Sets PEG2 B0:D1:F0 Gen1~Gen3. Configuration options: [Auto] [Gen1] [Gen2] [Gen3]
PEG0 ASPM [Disabled]
Sets the ASPM support for the PEG: Device 1 Function 2. This function does not take effect
if PEG is not the currently active device. Configuration options: [Disabled] [Auto] [ASPM L0s]
[ASPM L1] [ASPM L0sL1]
Enable PEG [Enabled]
Allows you to enable or disable the PEG (PCI Express Graphics). Configuration options: [Disabled]
[Enabled] [Auto]
De-emphasis Control [-3.5 dB]
Sets the De-emphasis control on the PEG. Configuration options: [-6 dB] [-3.5 dB]
PEG Sampler Calibrate [Auto]
Enables or disables the PEG Sampler calibration. Setting this item to [Auto] can disable SNB
MB/DT and enable IVB A0 B0. Configuration options: [Disabled] [Enabled] [Auto]