Asus P8Q77-M - Manual (Page 63)

Chapter 2: BIOS information 2-19
Swing Control [Reduced]
Sets the execution of the PEG Swing Control on IVB C0 and later. Configuration options: [Reduced]
[Half] [Full]
Gen3 Equalization [Enabled]
Enables or disables the execution of PEG Gen3 Equalization steps. Configuration options:
[Disabled] [Enabled]
Gen3 Eq Phase 2 [Auto]
Sets the execution of the PEG Gen3 Equalization Phase 2. Configuration options: [Disabled]
[Enabled] [Auto]
PEG Gen3 Root Port Preset Value for each Lane
Sets the Root Port Preset Value per lane for Gen3 Equalization.
Lane 0~15 [8]
Sets the value for each lane. Use the <+> and <-> keys to adjust the value.
PEG Gen3 Endpoint Preset Value for each Lane
Sets the Endpoint Preset Value per lane for Gen3 Equalization.
Lane 0~15 [8]
Sets the value for each lane. Use the <+> and <-> keys to adjust the value.
2.5.6 Intel TXT(LT) Configuration
Secure Mode Extensions (SMX) [Enabled]
Allows you to enable or disable the Intel Secure Mode Extensions (SMX) technology.
Configuration options: [Disabled] [Enabled]
Intel TXT(LT) Support [Disabled]
This item can be configured only when the Intel SMX, Intel Virtualization Technology (VT),
and Intel Virtualization Technology for Directed I/O (VT-d) technologies are all enabled.
Allows you to enable or disable the Intel Trusted Execution Technology. Configuration
options: [Disabled] [Enabled]
2.5.7 AMT Configuration
The items in this menu allow you to change the Intel ® Active Management Technology (AMT)
feature.
Intel AMT [Enabled]
Allow you to enable or disable the Intel ® Active Management Technology (AMT) in the BIOS
extension. Configuration options: [Enabled] [Disabled]
iAMT H/W is always enabled. This option just controls the BIOS extension execution. If
enabled, this requires additional firmware in the SPI device.
Invoke MEBx [Disabled]
[Enabled] Execute MEBx automatically.
[Disabled] Press <Ctrl+P> to invoke MEBx.
Un-Configure ME [Disabled]
Sets this item to [Disabled] to unconfigure AMT/ME without using a password or set it to
[Enabled] to use a password. Configuration options: [Enabled] [Disabled]