Asus GigaX2124X - Manual (Page 78)

GigaX Series L2 Managed Switch User’s Guide
78
CLI command : l2 mcast delete
mac address [format: xx:xx:xx:xx:xx:xx]: <multicast mac address>
vlan id: <vlan id>
[Reload]
Restores the previous saved settings from configuration file.
CLI command : l2 mcast retrieve
[IGMP is] [Enabled/Disabled]
Layer 2 IGMP snooping can be started or terminated by user if necessary.
CLI command : l2 igmp <start/stop>
[Reload]
Restores the previous saved settings from configuration file.
CLI command : l2 igmp retrieve
[Broadcast] [Enabled/Disabled]
[Multicast] [Enabled/Disabled]
[Destination Lookup Failure] [Enabled/Disabled]
User can limit the broadcast, multicast, and flooding (due to destination lookup
failed) traffic rate by turning the traffic control on.
CLI command : l2 rate set <1: bcast/2: mcast/3: dlf> <enable/disable>
[Limit]
Displays the current rate limitation value of the switch. User can change this
value by giving a new limit value. This value is applied to all of the traffic control
mentioned above.
CLI command : l2 rate limit <limit rate>