Asus TS300-E8-RS4-C - Manual (Page 41)

2-19 ASUS TS300-E8-RS4-C
2.6.5 Removing and reinstalling the backplane
DO NOT remove the backplane unless necessary!
4. Firmly hold the backplane, lift it
upwards. and remove it from the
module.
5. Follow the previous instructions in
reverse to reinstall the backplane.
6. Push the tray lever until it clicks
and secures the drive tray in place.
The drive tray is correctly placed
when its front edge aligns with the
bay edge.
7. Repeat steps 1 to 6 if you wish to
install another SATAII/SAS drive.
1. Remove all hot-swap HDD trays
from the chassis.
2. Disconnect all cables from the
SATA/SAS backplane.
3. Loosen the four screws on the
backplane.