Asus M2NPV-VM - Manual (Page 42)

1-30 Chapter 1: Product introduction
3. IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s).
There are three connectors on each Ultra DMA 133/100/66 signal cable: blue,
black, and gray. Connect the blue connector to the motherboard’s IDE
connector, then select one of the following modes to configure your device(s).
M2NPV-VM
®
M2NPV-VM IDE connectors
NOTE:.Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
SEC_IDE
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
Drive jumper setting Mode.of.
device(s)
Cable.connector
Single device Cable-Select or Master - Black
Two devices Cable-Select Master
Black
Slave Gray
Master Master Black or gray
Slave Slave