Asus M2NPV-VM - Manual (Page 43)

ASUS M2NPV-VM 1-31
4.. Serial.ATA.connectors... . . . .
(7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA 3.0
Gb/s hard disk and optical disk drives. The Serial ATA 3 Gb/s is backward
compatible with Serial ATA 1.5Gb/s specification.
The current Serial ATA I interface allows up to 150 MB/s data transfer rate
while Serial ATA II allows up to 300 MB/s data transfer rate, faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133).
If you install Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
RAID 0+1, RAID 5, and JBOD configuration through the onboard NVIDIA ®
MediaShield™ controller.
M2NPV-VM
®
M2NPV-VM.SATA.connectors
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA4
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA3
Important.note.on.Serial.ATA
Install the Windows
® 2000 Service Pack 4 or the Windows ® XP Service Pack1
before using Serial ATA.
• For detailed instructions on how to configure RAID 0, 1, 0+1, 5,and JBOD,
refer to the RAID manual in the support CD.
• The RAID function of these connectors is set to [Disabled] by
default. If you intend to create a Serial ATA RAID set using these
connectors, enable the RAID Enabled item in the NVRAID Configuration
sub-menu in the BIOS. See section “2.4.6 Onboard Device Configuration”
for details.