Asus M2NPV-VM - Manual (Page 75)

ASUS M2NPV-VM 2-25
Select Menu
Item Specific Help
Select Yes if you are using
a Plug and Play capable
operating system Select
No if you need the BIOS to
configure non-boot devices
PCIPnP
Plug & Play O/S [ No ]
Primary Display Adapter [PCI-E]
Resources Controlled By [Auto]
x IRQ Resources
** PCI Express relative itmes **
Maximum Payload Size [4096]
Phoenix-Award BIOS CMOS Setup Utility
Advanced
2.4.5. PCIPnP
Plug & Play O/S [No]
When set to [No], the BIOS configures all the devices in the system. When set to
[Yes] and if you install a Plug and Play operating system, the operating system
configures the Plug and Play devices not required for boot. Configuration options:
[No] [Yes]
Primary Display Adapter [PCI-E]
Sets which graphics controller to use as primary boot device.
Configuration options: [PCI] [Onboard] [PCI-E]
Resources Controlled By [Auto]
When set to [Auto], the BIOS automatically configures all the boot and Plug and
Play compatible devices. Set to [Manual] if you want to assign the IRQ DMA and
memory base address fields. Configuration options:
[Auto] [Manual]
When the item Resources Controlled By is set to [Auto], the item IRQ
Resources is grayed out and not user-configurable. Refer to the section “IRQ
Resources” for information on how to enable this item.
IRQ Resources
This sub-menu is activated only when the Resources Controlled By item is set to
Manual.
Select Menu
Item Specific Help
Legacy ISA for devices
compliant with the
original PC AT bus
specification, PCI/ISA PnP
for devices compliant with
IRQ Resources
IRQ-5 assigned to [PCI Device]
IRQ-7 assigned to [PCI Device]
IRQ-9 assigned to [PCI Device]
IRQ-10 assigned to [PCI Device]
IRQ-11 assigned to [PCI Device]
IRQ-14 assigned to [PCI Device]
IRQ-15 assigned to [PCI Device]
Phoenix-Award BIOS CMOS Setup Utility
Advanced