Asus P9D-I - Manual (Page 95)

ASUS P9D-I 5-5
3. From the LSI Software RAID Configuration Utility Management menu, use the
arrow keys to select an option then press <Enter>. Refer to the Management Menu
descriptions on the next page.
At the bottom of the screen is the legend box. The keys on the legend box allow you
to navigate through the setup menu options or execute commands. The keys on the
legend box vary according to the menu level.
5.2 LSI Software RAID Configuration Utility
The LSI MegaRAID software RAID configuration utility allows you to create RAID 0,
RAID 1, or RAID 10 set(s) from SATA hard disk drives connected to the SATA connectors
supported by the motherboard southbridge chip.
• The LSI MegaRAID software RAID configuration utility automatically configures to
RAID 1 when the SATA to RAID Mode is enabled.
• The RAID setup screens shown in this section are for reference only and may not
exactly match the items on your screen due to the controller version difference.
• When you create RAID sets with the LSI MegaRAID software RAID configuration
utility, the boot priority of the SATA optical drive has to be manually adjusted.
Otherwise, the system will not boot from the connected SATA ODD.
To launch the LSI MegaRAID software RAID configuration utility:
1. Turn on the system.
2. During POST, the LSI MegaRAID software RAID configuration utility automatically
detects the installed SATA hard disk drives and displays any existing RAID set(s).
Press <Ctrl>+<M> to enter the utility.
LSI MegaRAID Software RAID BIOS Version A.11 02090932R
LSI SATA RAID Found at PCI Bus No:00 Dev No:1F
Device present at Port 0 ST3160812AS 152114MB
Device present at Port 1 ST3160812AS 152114MB
Device present at Port 2 ST3160812AS 152114MB
Device present at Port 3 ST3160812AS 152114MB
Press Ctrl-M or Enter to run LSI Software RAID Setup Utility.
Use Cursor Keys to Navigate Between Items And Press Enter To Select An Option
LSI Software RAID Configuration Utility Ver C.05 Oct 26, 2011
BIOS Version A.11.02090932R
Configure VD(s)
Configure
Initialize
Objects
Rebuild
Check Consistency
Management Menu
Before you proceed, ensure that you have installed the Serial ATA hard disk drives, set
the correct jumper settings of the motherboard, and have set the correct SATA mode in
the BIOS setup. You can refer to sections
5.1.2 Installing hard disk drives, 5.1.3 Setting
Jumpers, and 5.1.4 Setting the RAID mode in BIOS for more information.