Asus RS300-H8-PS12 - Manual (Page 128)

6-18 Chapter 6: RAID configuration
6.4 LSI Corporation MPT Setup Utility
The LSI Corporation MPT Setup Utility is an integrated RAID solution that allows you to
create the following RAID sets from SAS hard disk drives supported by the LSI SAS 2308
Series controller: RAID 0, RAID 1, RAID 1E, and RAID 10.
• You may use disks of different sizes in one volume; however, the size of the smallest
disk determines the “logical” size of each member disk.
• DO NOT combine Serial ATA and SAS disk drives in one volume.
• The RAID setup screens shown in this section are for reference only and may not
exactly match the items on your screen due to the controller version difference.
• The adapter name shown on the setup screens differs according to the installed SAS
RAID card.
• Before requesting support from the ASUS Technical Support team, you have to take
note of the MPTFW and MPTBIOS version for the SAS RAID card. After entering the
SAS configuration utility, yaou can see below screen and identify the MPTFW and
MPTBIOS version:
MPTFW version: 5.00.00.00-IR
MPTBIOS version: v7.29.00.00 (2012.11.12)
Esc = Exit Menu F1/Shift+1 = Help
Alt+N = Global Properties -/+ = Alter Boot Order Ins/Del = Alter
Boot List
LSI Corp Config Utility v7.29.00.00 (2012.11.12)
Adapter List Global Properties
Adapter PCI PCI PCI PCI FW Revision Status Boot
BUS Dev Fnc Slot Order
Asus SAS2308-2 04 00 00 07 5.00.00.00-IR Enabled 0