Asus RS300-H8-PS12 - Manual (Page 139)

ASUS RS300-H8-PS12 6-29
Managing hot spares
You may configure one disk as a global hot spare to protect critical data on the RAID 1/1E/10
volume(s). You may create the hot spare disk at the same time you create the RAID 1/1E/10
volume. Refer to this section when adding a hot spare disk on an existing volume.
If a disk on an RAID 1/1E/10 volume fails, the utility automatically rebuilds the failed disk
data on the hot spare. When the failed disk is replaced, the utility assigns the replacement
as the new hot spare.
To create a hot spare:
1. Follow steps 1–3 of the section Viewing volume properties.
2. From the View Volume screen, select Manage Volume, then press <Enter>.
3. From the Manage Volume screen, select Manage Hot Spares, then press <Enter>.
Esc = Exit Menu F1/Shift+1 = Help
Enter = Select Item
LSI Corp Config Utility v7.29.00.00 (2012.11.12)
Manage Volume -- SAS2308-2
Identifier LSI Logical Volume 3000
Type RAID 1
Size(GB) 73
Status Optimal
Task None
Manage Hot Spares
Consistency Check
Activate Volume
Delete Volume
Online Capacity Expansion
Esc = Exit Menu F1/Shift+1 = Help
Enter=Select Item Alt+N=Next Volume
LSI Corp Config Utility v7.29.00.00 (2012.11.12)
View Volume -- SAS2308-2
Volume 1 of 1
Identifier LSI Logical Volume 3000
Type RAID 1
Size(GB) 73
Status Optimal
Task None
Manage Volume
Slot Device Identifier RAID Hot Drive Pred Size
Num Disk Spr Status Fail (GB)
0 ATA WDC WD800JD-22LS1D06 Yes No Primary No 73
1 ATA WDC WD800JD-22LS1D06 Yes No Secondary No 73