Armasight NSMAVENGE3GGDA1 AVENGER Gen 3 Ghost Night Vision Monocular - Manual (Page 5)

5
wARnIng :
consider the following information and restrictions in order to avoid damaging the device
and to ensure a long service life and failure-free operation:
• Performance of the device in nighttime conditions depends on the level of ambient light in the
environment. Some light (moonlight, starlight, etc.) is required for the device to provide an image.
• The level of ambient light is reduced by the presence of clouds, shade, or objects that block
natural light (buildings, trees, etc.).
• The device loses its effectiveness when operated in shadowed areas.
• The effectiveness of the device is adversely affected by weather conditions such as rain,
snow, sleet, and fog, as well as environmental conditions such as smoke or dust.
• The device resolution level is reduced in environments with very low light sources. The vis-
ibility will degrade significantly under starlight conditions, particularly in low contrast environ-
ments such as deserts, large areas of uniform vegetation, etc.
• The device is equipped with a protection system that will automatically disable the image
intensifier tube when the illuminance level stays above 40 lux for over 10 seconds.
bATTERY InSTAllATIOn
Install the CR123A battery as follows:
1) Unscrew the battery compartment cap on the front side of
the monocular’s body.
2) Insert the CR123A battery into the battery compartment in
accordance with polarity markings.
3) With the battery adapter installed, screw the battery cap
back on securely.
Install the AA battery as follows:
1) Unscrew the battery cap.
2) Remove the battery adapter from the cap.
3) Insert the AA battery into the battery compartment in ac-
cordance with polarity markings.
4) Screw the battery cap back on securely.
TRIPOD InSTAllATIOn
The Avenger can be connected to a tripod. To mount the Avenger on a tripod use the 1/4’’ threaded
socket located on the Avenger’s body.
nOTE:
The unit may be badly damaged if the tripod collapses or falls over. Remove the unit from the
tripod if it is not within your reach.
3. OPERATIOn InSTRucTIOnS
cOnTROlS
The Avenger is designed to meet the needs and requirements of various users. With the help of the
controls, each user can individually set the unit to the most effective and desirable position. The Aveng-
er unit’s controls and indicators are shown and detailed further, below.