Armasight NSGN150001F6DA1 N-15 FLAG Night Vision Goggles - Manual (Page 19)

19
2. Align the adapter prism (E) with the helmet/ headgear assembly mount (F). Slide the N-15 until its
alignment boss is in line with the alignment groove on the helmet/ headgear assembly mount. Push
down until the N-15 locks into the helmet/ headgear assembly mount.
To dismount the N-15 from the helmet/ headgear assembly, push down on the lever (G) and remove
the unit.
Loosen the screw (A), push the button (B) and remove the adapter from the N-15 rail.
3.1.5 MOUNTING AN IR ILLUMINATOR TO THE N-15
To mount an IR illuminator to the N-15, use the optional Dovetail to Weaver Transfer Piece. Perform the
following steps:
1. Install the transfer piece (A) onto one of the N-15 rails.
2. Tighten the fixing screw (B) on the transfer piece .
3. Loosen the IR illuminator fixing screw (C).
4. Mount the IR illuminator on the Weaver rail of transfer piece and tighten the fixing screw (C).
3.1.6 MOUNTING A CAMERA/ CAMCORDER TO THE N-15
To mount any 35mm SLR photographic camera or 8mm camcorder to the N-15, use the optional camera
adapter and perform the following:
1. Using the (M37x0.75 threaded) adapter ring (B), screw the (M52x0.75 threaded) adapter (A) into the
front lens of the photographic camera or video camera.
2. Remove the eyecup from the N-15 eyepiece.
3. Connect the adapter with the eyepiece and tighten the three fixing screws (C) located on the adapt-
er.
3.1.7 MOUNTING 3X AFOCAL LENSES TO THE N-15
To mount the 3x afocal lenses to the device, screw it into the threading of the standard 1X objective
lenses of the N-15.
FIGURE 3-5. MOUNTING AN IR ILLUMINATOR TO THE N-15
B
C
A
B
C
FIGURE 3-6. CAMERA ADAPTER
A