YSI 60 - Manual (Page 16)

12
FULL
Once you have acknowledged the memory is full, any subsequent saved data will begin
overwriting existing data starting with site #1. No additional warning will be displayed.
4.5 Recalling Stored Data
1. To put the Model 60 into the RECALL mode, press the MODE key until “rcl” is displayed
on the screen along with the site ID number in the lower right corner.
rcl
01
Site identity
2. Press the ENTER key to review the last set of data that was saved. The Model 60 will
display the pH and temperature.
3. Press the UP ARROW key to move up through the saved sets of data.
4. Press the DOWN ARROW key to move down through the saved sets of data.
5. When the correct Site ID# is displayed, press the ENTER key to display the data.
6. When you have finished recalling data, press MODE two times to return to normal
operation.
NOTE: The Model 60 will recall data as a list. When the UP ARROW is pressed the Model 60
will display the Site ID# for the previously recorded data. For example: If you are reviewing Site
ID# 5 and the UP ARROW is pressed, the Model 60 will display Site ID#4. If you are reviewing
Site ID# 5 and Site ID# 5 was the last set of data stored, the DOWN ARROW key will display
Site ID# 1.
Here is an example of the Model 60 memory.
Site ID #1
Site ID #2
Site ID #3 If the UP ARROW key was pressed the Model 60 would display Site ID #2
Site ID #4
Site ID #5