YSI 900 Chlorine Colorimeter - Manual (Page 17)

17
ENGLISH
Mode
!
SET
DATE
YYYY
(2 sec.)
Mode
Zero
Test
E 132
If the instrument is not able to communicate with the IRiM, a timeout occurs after
approx. 2 minutes. The error E 132 is displayed for approx. 4 seconds. Subsequently,
the instrument returns to test mode (see also 900 series Data Hub manual).
2
setting date and time (24-hour-format)
After confirming the selection with the [MODE] key the value to be edited will be
shown for 2 sec.
The setting starts with the year (YYYY) followed by the actual value to be edited. The
same applies for month (mm), day (dd), hour (hh) and minutes (mm). Set the minutes
first in steps of 10, press the [!] key to continue setting the minutes in steps of 1.
Increase the value by pressing the [MODE] key.
Decrease the value by pressing [ZERO/TEST] key.
Proceed to the next value to be edited by pressing [!] key.
After setting the minutes and pressing the [!] key the display will show “IS SET” and
the instrument returns to the measurement mode.
2
Store Date
Print Time