YSI VisoTurb 700 IQ - Manual (Page 45)

VisoTurb
®
700 IQ (SW) Indexes
9 - 1 ba76039e01 01/2012
9 Indexes
9.1 Explanation of the messages
This chapter contains a list of all the message codes and related
message texts that can occur in the log book of the IQ S
ENSOR N ET
system for the VisoTurb
®
700 IQ (SW) sensor.
Note
Information on
 the contents and structure of the log book and
 the structure of the message code
is given in the L OG BOOK chapter of the IQ S ENSOR N ET system
operating manual.
Note
All message codes of the VisoTurb
®
700 IQ (SW) end with the number
"341".
9.1.1 Error messages
Message code Message text
EA2341 Sensor temperature too high!
* Check process and application
EA3341 Sensor temperature too low!
* Check process and application
EA6341 Meas. range exceeded or undercut
* Check process
* Select other meas. range
* Submerse sensor in sample
* Select bubble-free spot for measurement
* Remove any foreign matter from sensor
* Avoid influence of large foreign matter
* Clean sensor
* Increase signal average time
EA7341 Ultrasound cleaning system switched off
* Check sample temperature
* Submerse sensor in sample
EI1341 Operational voltage too low
* Check installation and cable lengths, Follow installation instructions
* Power unit(s) overloaded, add power unit(s)
* Defective components, replace components