Extron Electronics DVI 201xi Tx User Guide - Manual (Page 15)

Twisted Pair Cable Connections
The DVI 201xi Tx is a single link DVI transmitter. It is compatible with all Extron single link
HDMI and DVI receivers (which must be purchased separately):
z z DVI 201 Rx
z z HDMI 201 Rx
z z DVI 201 A D Rx
z z HDMI 201 A D Rx
The transmitter can also be used with appropriate dual link receivers (for example, the
DVI DL 201 Rx), if they are used in single link mode.
Use two CAT 5, 5e, or 6 twisted pair cables or Extron DTP26 cables, terminated with RJ-45
connectors, to link the output from the transmitter to the appropriate input on the receiver.
Extron recommends 28AWG to 24AWG twisted pair cable for the RJ-45 connectors. For
resolutions of 1600x1200, 1920x1200, and 1080p, Extron strongly recommends DTP26
cable, or equivalent.
Connect the output from the transmitter to the input of the receiver that has the same
number:
z z Transmitter port 1 connects to receiver port 1
z z Transmitter port 2 connects to receiver port 2
Single Link DVI transmission distances
Single Link DVI carries signals at resolutions up to1080p and 1920x1200 @ 60 Hz.
Video Resolution (60 Hz) Single Link Mode
UTP STP
1024x768
200 feet
(60 m)
200 feet
(60 m)
720p
1080i
1920x1200
100 feet
(30 m)
125 feet
(38 m)
1600x1200
1080p
NOTE: The transmission distance varies greatly depending on signal resolution, and on
the type of cable, graphic card, and display used in the system.
DVI 201xi Tx • Panel Features and Connections 9