Extron Electronics FOXBOX Tx_Rx DVI Plus User Guide - Manual (Page 10)

System Compatibility
The FOXBOX Tx DVI Plus transmitter fiber optic output signal can be received only by a
FOXBOX Rx DVI Plus receiver.
All fiber optic signals from all other units are interchangeably compatible between VGA and
DVI units, Plus and non-Plus units, and PowerCage Fox and FOX 500 units as shown in the
following table.
Receiver Compatible transmitter(s)
FOXBOX Rx VGA FOXBOX Tx VGA
FOXBOX Tx VGA/YUV
FOXBOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
PowerCage FOX Tx DVI (non-Plus)
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
FOXBOX Rx DVI Plus FOXBOX Tx DVI Plus
FOXBOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOXBOX Tx VGA/YUV
PowerCage FOX Tx DVI Plus
PowerCage FOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
FOXBOX Rx DVI (non Plus) FOXBOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOXBOX Tx VGA/YUV
PowerCage FOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
NOTES: • The FOXBOX units are fully compatible with all Extron FOX 500 products and
a variety of other fiber optic products. Those other products are identified
where appropriate, but not specifically described in this manual.
• The FOXBOX DVI does not support the transmission of signals with High-
bandwidth Digital Content Protection (HDCP).
FOXBOX Tx/Rx • Introduction 4