Extron Electronics FOXBOX Tx_Rx DVI Plus User Guide - Manual (Page 31)

Command/response table for SIS commands (continued)
NOTE: X! = Mute and auto memory status 0 = off 1 = on
X1& = Test pattern 0 = none 2 = grayscale
1 = color bars 3 = alternating pixels
X1( = Rx link 0 = disable 1 = return link enable
X1* = Video shutdown interval 0 = 0 sec. (off) 2 = 0.5 sec. 4 = 1 sec. 6 = 1.5 sec.
1 = 0.25 sec. 3 = 0.75 sec. 5 = 1.25 sec.
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Audio mute
Mute the audio 1Z Amt1 ] Silence the audio output of the receiver.
Unmute the audio 0Z Amt0 ] The receiver outputs audio.
Show audio mute statue Z X!] Audio mute status is X! .
Auto memory
Disable auto memory 55*0# Img0 ]
Enable auto memory 55*1# Img1 ]
Show auto memory status 55# X!]
Auto Image™
Trigger Auto Image 55*2# Img ]
Test pattern
NOTE: You must have a video input connected and the transmitter-Tx-to-receiver-Rx fiber cable connected for the receiver to output a
selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power is removed.
Output color bars 1J Tst1 ] Set the receiver to output the color bars test pattern.
Output grayscale 2J Tst2 ] Set the receiver to output the grayscale test pattern.
Output alternating pixels 3J Tst3 ] Set the receiver to output the alternating pixels test
pattern.
Turn test pattern off 0J Tst4 ] Set the receiver to output the input video (no test
pattern is selected).
Show test pattern status J X1&]
Disable and enable return link
NOTE: The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the
receiver is connect to any of outputs 2 through 6 on the DA.
Disable return link 66*0*0# Rle*0*0 ] Disable link 2.
Enable return link to
transmitter 66*0*1# Rle*0*1 ] Enable link 2 (default setting).
Show return link status 66*0# 0* X1^]
Video shutdown delay
NOTES: • This command mutes the output for a variable period of time when the unit detects a change in the input pixel clock.
0.5 second is the default. This feature can prevent glitches when the input video signal resolution changes.
• Front panel DIP switch 2 must be on (up) for this command to function.
Enable video shutdown 3* X1* # Dly X1*] Mute the output for an interval of X1* .
Example: 3*3# Dly3 ] Mute the output for 0.75 second.
View video shutdown 3# X1*] The video shutdown interval is X1* .
FOXBOX Tx/Rx • Remote Control 25