Transmitter rear panel features – Extron Electronics MTP 15HD A Series User Guide Rev. C User Manual

Page 13

Advertising
background image

J

Delay (skew adjustment) control (SEQ model only) — This control delays the
selected Red, Green, or Blue video signal by up to 62 nanoseconds. The delay is
applied in incremental, 2-nanosecond steps. Rotate the control counterclockwise to
reduce the delay or clockwise to increase the delay.

NOTES:

•

The control turns smoothly; it does not have mechanical steps or high and low
limit stops.

•

Watch the displayed image to observe the steps of delay.

•

The selected Red, Green, or Blue LED (

I

) flashes to indicate that the control

has reached the minimum (counterclockwise rotation) or maximum (clockwise
rotation) limit.

K

DIP switches (RL receivers only) — A 5-pole DIP switch is used to configure the
features of the MTP receivers.

•

•

Horizontal sync (H Sync +) switch — Set this switch On (up) for positive
horizontal sync or Off (down) for negative sync.

•

•

Vertical sync (V Sync +) switch — Set this switch On (up) for positive vertical
sync or Off (down) for negative sync.

NOTE: Most devices use negative sync for H Sync and V Sync.

•

•

S-Video switch — This switch is used to set which pins of the 15-pin HD
connector S-video is output on.

•

•

Set this switch On (up) to output chroma on pin 3 and luma on pin 2.

•

•

Set this switch Off (down) to output chroma on pin 1 and luma on pin 2.

•

•

End Unit switch — Set this switch On (up) if either of the following is true:

•

•

The receiver being configured is the only receiver connected to the transmitter.

•

•

The receiver being configured is the last receiver in a daisy-chained system.

Set the End Unit switch Off (down) on the receiver being configured if there are one
or more receivers connected to the Buffered Output RJ-45 connector (see

C

on

page

11

).

MTP 15HD A Series • Installation and Operation

8

Advertising