Transmitter rear panel features, Connect the transmitter inputs (see, Transmitter rear panel – Extron Electronics MTP 15HD A Series User Guide Rev. C User Manual

Page 14: Features

Advertising
background image

Transmitter Rear Panel Features

Figure 3 shows an MTP T 15HD A transmitter, which has all of the connectors and other
features that are on either transmitter in the MTP 15HD A series.

MTP T 15HD A Transmitter

OUTPUT

INPUT

AUDIO

POWER

12V

0.5A MAX

MONITOR

PRE-PEAK

ON

OFF

MTP T 15HD A

F

E

C

B

A

D

Figure 3.

Transmitter Rear Panel

NOTE: A "C7" label is affixed to transmitters designed for STP201 or CAT 7 cable.

A

Power connector — Plug the included external 12 VDC power supply into this
2-pole captive screw connector (see

Power Supply Wiring

on page 13 to wire the

connector).

NOTES:

•

The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inches (5 mm). If the exposed section is longer, the exposed wires
may touch, causing a short circuit between them. If it is shorter, the wires can be
easily pulled out, even if tightly fastened by the captive screws.

•

Do not tin the wires. Tinned wire does not hold its shape and can become loose
over time.

B

Input video connector — Connect a video source to this 15-pin HD connector for
high resolution video input (see figure 4).

5

1

15

11

6

10

Female

Figure 4.

15-pin HD Connector

NOTES:

•

Input only sync signals (no video signals) on the sync pins (13 and 14).

•

For component video, use the R (R-Y) and R return pins (pins 1 and 6),
G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins
(pins 3 and 8). For S-video, use the R, R return (C-chroma), G, and
G return (Y-luma) pins.

•

For composite video, use the G pin and the associated return pin. For additional
genlocked video signals, use the R, B, and associated return pins.

C

Monitor (loop-through) connector — Connect a video monitor to this 15-pin HD
connector for buffered, high resolution video loop-through.

A

Power Connector

B

Input video connector

C

Monitor (loop-through)

connector

D

Audio input connector

E

Pre-Peak switch

F

Output connector

MTP 15HD A Series • Installation and Operation

9

Advertising