Extron Electronics MTP 15HD A Series User Guide Rev. C - Manual (Page 15)

D Audio input connector — Plug a 3.5 mm stereo audio plug into this connector for
unbalanced audio input. Wire the plug as shown in figure 5. The stereo audio input is
summed and output on the twisted pair cable as mono audio.
Sleeve ( )
Ring
Right (-)
Tip
Left (+)
Figure 5. 3.5 mm Stereo Audio Plug
E Pre-Peak switch — The Pre-Peak switch alters the twisted pair signal output to
correct for long cable runs (see the
table on page 4 for suggested switch settings
based on the transmitted video format and transmission distance).
F Output connector — Connect one end of a twisted pair cable to this RJ-45 female
connector on the transmitter. Connect the free end of the same twisted pair cable to
the RJ-45 female connector on the receiver (see
Twisted Pair Cable Termination on
page 15 to wire the RJ-45 connectors).
ATTENTION: Do not connect these devices to a computer data or
telecommunications network.
MTP 15HD A Series • Installation and Operation 10