Extron Electronics MTP 1500RL 15HD A SEQ User Guide - Manual (Page 10)

Installation and
Setup
This section describes how to connect applicable cables to the MTP 1500RL A SEQ receiver.
It covers:
z Rear Panel Features
z
Power Supply Wiring
z TP Cable Termination
Rear Panel Features
Rear panel connectors and features for the MTP 1500RL A SEQ receiver is shown below.
POWER
12V
1A MAX
MTP 1500RL 15HD A SEQ
OUTPUT
MONO
L R
AUDIO
INPUT BUFFERED OUTPUT
ON
H
+
V
+
CSYNC SOG VIDEO END SP
ARE
MTP MTP
5 6 1 2 4 3
Figure 3. Rear Panel Features of the MTP 1500RL 15HD A SEQ
a
Power connector — Plug the included external 12 VDC, 1 A, power supply into this
2-pole captive screw connector (see “ Power Supply Wiring” section for wiring details).
CAUTIONS: • Always use a power supply supplied or specified by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification
and may cause damage to the supply and the end product.
• Unless otherwise stated, the AC/DC adapters are not suitable for use in
air handling spaces or in wall cavities.
• The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75 and the
Canadian Electrical Code part 1, section 16.
• The power supply must not be permanently fixed to building structure
or similar structure.
b
Input connector — Connect one end of the twisted pair cable from an MTP transmitter
to this RJ-45 connector (s ee “TP Cable Termination” to wire the connector).
CAUTION: Do not connect these devices to a computer data or telecommunications
network.
c
Buffered output connector — Connect up to 5 daisy-chained MTP receivers to
this RJ-45 connector.
NOTE: In a daisy-chain, the maximum distance from video source to display device
should not exceed 1500 feet.
MTP 1500RL 15HD A SEQ • Installation and Setup 4