Extron Electronics MTP 1500RL 15HD A SEQ User Guide - Manual (Page 11)

d
High resolution video output connector — Connect a projector or other high
resolution video device to this 15-pin HD connector for RGB output.
NOTE: See DIP switch settings for signal format output.
e
Audio connector — Connect a suitable audio device to the 5-pole captive screw
connector for mono audio output.
1
MONO A
UDIO
2
1
MONO A
UDIO
2
Unbalanced Output Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the negative (-) contacts.
Figure 4. Audio Connector Wiring
f
Receiver DIP switches — Set these DIP switches for the applicable signal.
z
H sync (H+) and V sync (V+) switches — Set these switches up for positive
sync or down for negative sync.
z
Composite sync (CSync), Sync on green (SOG), and Video switches —
Set these switches as shown in the table below to output the indicated format.
Output Format C Sync SOG Video
RGBHV < < <
RGBS > < <
RGsB < > <
Component video* < < >
S-video < < >
Composite video* < < >
* Input video format must match.
< = switch is down > = switch is up
z
End unit switch — Set this switch up if either of the following is true:
z
The receiver being configured is the only receiver connected to the transmitter.
z
The receiver being configured is the last receiver in a daisy-chained system.
ON
H
+
V
+
CSYNC SOG VIDEO END SP
ARE
MTP 1500RL 15HD A SEQ • Installation and Setup 5