Extron Electronics MTP 1500RL 15HD A SEQ User Guide - Manual (Page 17)

Reference
Information
This section provides information about:
z Specifications
z
Part Numbers and Accessories
Specifications
Video
Gain ............................................... Unity
Number/signal type ........................ 1 set of proprietary analog signals
Connectors .................................... 1 female RJ-45
Video input — see MTP Series transmitters specifications
Video output — receiver
Number/signal type ........................ 1 set of proprietary analog signals
1 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi- or tri-level sync), S-video, or
composite video
Connectors .................................... 1 female RJ-45
1 female 15-pin HD
Nominal level ................................. 1 V p-p for Y of component video and S-video, and for composite video
0.7 V p-p for RGB and for R-Y and B-Y of component video
0.3 V p-p for C of S-video
Minimum/maximum levels .............. 0.3 V to 1.45 V p-p
Impedance ..................................... 75 ohms
Return loss ..................................... <-30 dB @ 5 MHz
DC offset ....................................... <±35 mV with input at 0 offset
Skew compensation ....................... 62 ns
Maximum resolution ...................... Up to 1600x1200 and 1080p at 1500'; 1920x1200 and 2048x1080 at 1200'
Sync
Output type ................................... RGBHV, RGBS, RGsB, RsGsBs
Standards ....................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Output level ................................... 0.3 Vp-p for component video (bi-level sync)
0.6 Vp-p for component video (tri-level sync)
TTL: 4.0 V to 5.0 V p-p, unterminated for RGBHV, RGBS
Output impedance ......................... 110 ohms
Polarity ........................................... Positive or negative (switch-selectable)
Audio
Number/signal type ........................ 1 set of proprietary analog signals
Connectors .................................... 1 female RJ-45
Gain ............................................... Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response ........................ 20 Hz to 20 kHz, ±1 dB
THD + Noise ................................... 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level
S/N ................................................. >70 dB at maximum output (unweighted)
Stereo channel separation .............. >60 dB @ 1 kHz
CMRR ............................................ >43 dB @ 20 Hz to 20 kHz
Audio input — See MTP Series transmitters specifications
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
MTP 1500RL 15HD A SEQ • Reference Information 11