NXG Technology NX-RF200 - Manual (Page 11)

By looking at the Signal column, you can see that the factory default pro-
gramming sets all of the devices to send both IR and RF commands. If you
look at the column for Flashers, you can see that the default sends IR com-
mands for all devices to ALL of the flashers. Both options must be changed
for identical components. Additionally, you must disable the Front Blaster
(see page 6 for directions).
Step 3 - Adjust the Signal For Each of the Identical Devices
The RF Setup window enables you to adjust the Signal output for each
device individually, by clicking on the intersection of a row and a column
and then selecting RF from the three options shown in the pull down list
box.
Select RF from the three options shown for each of the identical TVs.
You may leave the other components of the system set to IR & RF.
Step 4 - Adjust the Flashers For Each of the Identical Devices
The RF Setup window enables you to adjust which Flashers output by the
remote control for each device individually, by clicking on the intersection
of a row and a column and then selecting 1-4 from the seven options
shown in the pull down list box.
Select the correct Flasher (refer to your connection notes) for each of
the identical TVs. You may leave the other components of the system
set to ALL.
See figure on the next page.
NX-RF200 Base Station
8
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 11