NXG Technology NX-RF200 - Manual (Page 6)

1. Unplug the NX-RF200. Test all IR commands and macros line of sight.
2. Power on all AV components including the TV. Turn on all of the lights
and lower all dimmers to 50%. Power on anything that may create RF
Interference (particularly devices with high speed microprocessors or hard
drives).
3. Check that the address wheel on the rear of the NX-RF200 is set to ID#0
(the interference “sniffing” position).
Check that the arrow pointer in the center of the wheel is pointed to 0,
the default “interference sniffing” position. If it is not, use a small flat
blade screwdriver (included) to set the RF ID# to 0.
4. Connect the NX-RF200 to its DC wall adapter and plug the wall adapter
into a live AC outlet. Place the NX-RF200 in a location at least 3 feet away
from satellite receivers, cable boxes, HDTV tuners, DVRs, PCs or any other
device with a high speed microprocessor (these generate broad band Radio
Frequency Interference -RFI). Of course, you should keep in mind that the
emitter cables are 10’ long.
NX-RF200 Base Station
3
The green POWERLED
indicates that the NX-RF200
is powered on.
The red STATUSLED flashes
differently, based on the
Address setting:
IF SET TO ID#0
The Status LED flashes
when it receives ANY RF
signal, including RFI. This
makes ID#0 ideal for
“sniffing” out RFI.
IF SET TO ANY OTHER ID#
The Status LED flashes ONLY
when it receives a correctly
addressed RF command.
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 6