NXG Technology NX-RF200 - Manual (Page 9)

Front Blaster Overload
A few models of audio/video components can be overloaded by the Front
Blaster. If you are having intermittent or inconsistent results with a particu-
lar component, try repositioning the NX-RF200 and facing the Front Blaster
in a different direction. If this improves the situation but is impractical, it
may be necessary to utilize the self-adhesive flashers only and follow the
steps below to Disable the Front Blaster. This will limit the number of com-
ponents your can control to four. If you have more than four components
you can purchase an additional NX-RF200.
Disabling the Front Blaster - Step by Step via PC
Note: If you are programming a NXG NX-RM “addressable” remote con-
trol that sets up without a PC, refer to the owners manual to disable the
Front Blaster.
Open the PC software, then plug the NX-RM PC programmable remote
control into the PC. Open your saved configuration and follow these
steps to turn off the front blaster:
Step 1 - Open the RF Setup Window
The RF Setup window opens after selecting RF Control or Settings from the
Program Menu of most NX-RM editors or from the Main Menu of the NX-
RF200.
Step 2 - Setup the Receiver
Extend the RF Setup window by clicking on the
Receivers button.
Step 3 - Turn off the Front Blaster
Click on the cell in the IR LED OUT-
PUT/IR BLASTER column. A list box
will appear. Select OFF from the list.
Next, click on Close to apply your change.
NX-RF200 Base Station
6
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 9