Elmo Rietschle G-BH9 - Manual (Page 20)

Installation
610.44434.40.000 20 / 32 © Gardner Denver Deutschland GmbH
5.3.3 Procedure when connecting
pipes/hoses
Attach the pipes/hoses to the unit as described in the
following. The pipes/hoses are connected differently to
inlet and discharge connections depending on the
muffler design and the type of line (pipe or hose):
 Muffler with inside threads:
The pipe is screwed directly into the muffler.
 Muffler without inside thread:
– Screw threaded flange (available as an
accessory) onto the muffler.
– Screw the pipe into the threaded flange.
 Hose connection:
– for 2BH1 Screw the hose flange (available
as an accessory) onto the silencer.
– Push the hose onto the hose flange and secure
it with a hose clamp. See Chapter 3.1,
"Mechanical data", Section "Tightening torques
for screw connections", Pg. 10 for information on
this topic.