Franklin Fueling Systems TS-1001, BulkStik, AutoStik (except AutoStik II 8Ch) Ribbon Cable (P/N 600-0077 & 600-0032) User Manual
Replacement part instructions
www.franklinfueling.com
0000205
Rev.B
E - m a i l :
t e c h @ f r a n k l i n f u e l i n g . c o m
F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2
T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6 P A G E
1 o f
1
s a l e s @ f r a n k l i n f u e l i n g . c o m
F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8
T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
Replacement
Part
Instructions
TS-1001, BulkStik, AutoStik (except AutoStik II 8Ch)
Ribbon Cable
(P/N 600-0077 & 600-0032):
Cable glossy side up / to the right
silver conductor side down / to the left.
Diagram: 1
Removal (with all Tank Gauge power
OFF
):
•
Remove ribbon cable by pulling it straight out
of its connector (see above).
NOTE: The 26 conductor printer cable is P/N 600-0032 and the 20 conductor Display
and Keypad cable is P/N 600-0077.
Installation (with all Tank Gauge power
OFF
):
•
Install the cables back into the appropriate connector gloss side up or to the right
(silver conductor side down or to the left). Do this by grasping the flat ribbon cable
near the end and pushing it straight into its connector.
—
❖ —