ABUS TVHD60010 - Manual (Page 23)

23
Important safety information
All guarantee claims are invalid in the event of damage caused by non-compliance with
this user guide. We cannot be held liable for resulting damages.
In the event of material or personal damage caused by improper operation or non-
compliance with the safety information, we cannot be held liable. All guarantee claims
are invalid in such cases.
Dear customer,
The following safety information and hazard notes are not only intended to protect your health, but
also to protect the device from damage. Please read the following points carefully:
 There are no components inside the product that require servicing by the operator. Opening or
dismantling the product invalidates the CE certification and guarantee claims / warranty.
 The product can be damaged if it is dropped, even from a low height.
Avoid the following adverse conditions during operation:
 Moisture or excess humidity
 Extreme heat or cold
 Direct sunlight
 Dust or flammable gases, vapors, or solvents
 Strong vibrations
 Strong magnetic fields (e.g. next to machines or loudspeakers)
 The camera must not be installed on unstable surfaces
General safety information:
 Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging, etc.,
can pose a danger to children if played with.
 The surveillance camera contains small parts which could be swallowed, and should be kept out of
reach of children for safety reasons.
 Do not insert any objects into the device through the openings.
 Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.
 Please pay attention to the safety information and user guides for the other connected devices.
 Check the device for damage before commissioning. Do not put the device into operation if you detect
any damage.
 Adhere to the operating voltage limits specified in the technical data. Higher voltages could destroy
the device and pose a health risk (electric shock).
When installing the device in an existing video surveillance system, ensure that all devices are
disconnected from the power supply and low-voltage circuit.
If in doubt, have a specialist technician carry out assembly, installation, and connection of the
device. Improper or unprofessional work on the power supply system or domestic installation
puts both you and other persons at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always run
separately
from each other. They should not be connected at any point or become connected as a result of
a malfunction.