ABUS TVIP62500 - Manual (Page 50)

50
3.5 Description of the status LEDs
State Description
Off
IP address assignment
On IP address assignment successful
Max. 3 x flash Communication to IR LED PCB/
light sensor established
3.6 Description of the reset button function
Restoring the factory settings
a) Remove the power supply unit from the camera.
b) Press the reset button.
c) Reattach the power supply unit whilst holding down the reset button, then keep it held down
for 10 seconds.
Restarting
a) The camera is restarted if the reset button is pressed once briefly.