Aeromotive 17204 - A2000 CARBURETED FUEL SYSTEM (DUAL CARB) - Manual (Page 5)

Section 2 - Fuel Pressure Regulator Installation:
2-1. Find a suitable place in the vehicle’s engine compartment to mount the Aeromotive regulator. Using the supplied
mounting bracket as a template, mark the bracket mounting holes and drill to accept a #10 screw.
2-2. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two #10 screws, nuts
and lock washers.
2-3. Place one of the supplied AN-10 o-rings on the cutoff side of the AN-10 union.
2-4. Thread the cutoff side of the AN-10 union into the base of the fuel pressure regulator. Depending on the regulator
mounting, either one of the two AN-10 ports can be utilized.
2-5. Place one of the supplied AN-10 o-rings on the AN-10 port plug.
2-6. Thread the AN-10 port plug into the remaining AN-10 port.
2-7. Attach the AN-10 fuel supply line to the regulator inlet (located at the base of the regulator).