Aeromotive 17241 - BB CHEVY BELT DRIVE KIT - Manual (Page 4)

12. Place one of the 1/8” square keys in the keyway on the pump.
13. Slide the 28-tooth pulley on to the pump shaft.
14. Thread the 10-32 x 1/2” setscrew into the side of the 28-tooth pulley; leave the assembly loose until final alignment can
be determined.
15. Using a straightedge align the pulley on the crankshaft with the pulley on the fuel pump. Alignment may be achieved by
moving the pump location in the mounting bracket and by moving the location of the 14-tooth pulley on the drive
mandrel. In some cases it may be necessary to shorten the pump bracket spacers to accommodate other
accessories on the drive mandrel.
16. Once the pulleys are aligned, tighten the pump bracket screw and both pulley setscrews. It is recommended to use a
removable Loc-tite thread locker on the setscrews to prevent them from loosening during operation.