Aeromotive 17241 - BB CHEVY BELT DRIVE KIT - Manual (Page 5)

17. Install the drive belt onto the pulleys and apply tension to the belt by rotating the pump along the slots in the bracket.
The belt tension should be adjusted such that the center of the belt will deflect 1/8”. Once this desired tension is
achieved, tighten the two 3/8” bolts holding the bracket to the spacers.
18. Identify which port is the inlet by comparing your installation with the diagram below.
19. Place several drops of a clean, general-purpose light oil into the inlet side of the pump to aid in the initial priming of the
fuel system.
20. Connect the fuel cell sump to the fuel filter inlet, we recommend using fuel filter Aeromotive p/n 12302, utilizing a
minimum of AN-10 steel braided fuel line. Next, connect the fuel filter outlet to the fuel pump inlet utilizing a minimum
of AN-10 steel braided fuel line, refer to Figure 1 for determining the fuel pump inlet. It is recommended that a front
mount fuel cell be used for best results.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components, and any exhaust
components! Protect fuel lines from abrasion and track obstructions or debris.