Aeromotive 17157 - COBRA JET BACK HALF FUEL SYSTEM - Manual (Page 2)

Figure 1-1
1-6. Find a suitable place for the two tank vent pass through fittings (15645), typical locations is trunk floor. Drill two holes
making sure you place them in a location where you can get access to the back side for the lock nuts. The system
comes with two tanks vents and both must be used for the system to function properly.
1-7. Assembly two identical hoses, 90 degree hose end on one side and a straight on the other. These will be used for the
tank vent hoses, Figure 1-2.
Figure 1-2
1-8. Next find a place for the two AN-08 fuel bulk heads, p/n 15685. The most common place for the two bulk heads are
on the driver’s side in the spare tire well. Drill the two holes two inches apart, figure 1-3.