Aeromotive 17158 - COBRA JET COMPLETE FUEL SYSTEM - Manual (Page 8)

2-25. Assemble the pressure sensor adapter (15115) with the two remaining AN-08 fittings (15607). Make sure the AN-
08 fitting have o-rings installed on them, if not do that at this time.
2-26. Assemble a hose with a straight AN-08 hose end on one end with a 180 degree hose end on the other. Attach this
hose to the front of the passenger side rail using the 180 degree end. Place the pressure sensor re-locator on the
other end as pictured.
2-27. Make up another hose with a straight hose end/180 degree hose end to complete the feeds to the regulator.
2-28. Assemble two identical hoses from the Y-Block (15674) using 45 degree fittings on one end and straights on the
other.
Make sure these lines are not resting against wires or hoses as they will chaff them over time.